BACK IN OF STOCK - Orders will ship out on Monday




Tesla compatible J1772 adapter.

With this adapter cable you can charge your non-Tesla EV on a Tesla Destination, UMC, or Wall Connector charger.

The adapter has a special circuit that allows it to work on any current Tesla charger including Destination Chargers.

This adapter cable has all of the pins needed to maintain all functionality and safety protocols used by UMC and J1772 charging systems.

This is compatible with all portable and stationary chargers from 110-250VAC.

It is recommended that you verify that the charger you are connecting to does not exceed your EV's voltage rating.

To the best of our knowledge the adapter should be compatible with any vehicle that uses the J-1772 connector and protocols up to 19.2 KW.

The TeslaTap will work on ALL EV's made in the US *

The TeslaTap has been tested on the following:

Audi A3 E-Tron
BMW i3
BMW i8
BMW 330e
BMW X5 xdrive40e
Cadillac ELR
Chevrolet Bolt
Chevrolet Volt
Chevrolet Spark EV
Chrysler Pacifica Hybrid *
Fiat 500e
Focus EV
Ford C-max Energi
Ford Focus Electric
Ford Fusion Energi
Honda Accord Plug-in Hybrid
Hyundai Sonta Plug-In Hybrid
Hyundai Ioniq
Jaguar I Pace **
Kia Soul EV
Mitsubishi i-MiEV
Mercedes B250e
Mercedes C350 Plug-in Hybrid
Mercedes S550 Plug-in Hybrid
Mercedes-Benz GLE550e
Mercedes B-Class Electric Drive
Nissan LEAF
Porsche Cayenne S E-Hybrid
Porsche Panamera S e-Hybrid
Porsche Tycan
Porsche 918 Spyder
Smart ForTwo Electric Drive
Toyota Prius Plug-in
Toyota Prius Plug-in Hybrid
Toyota RAV4
Toyota Prius
Toyota Prius Prime (Plug-in Hybrid)
Volkswagen e-Golf
Volvo XC90 T8

The high power TeslaTap was tested to 150AMPS for 2 hours. (I am sure that it would test higher but that is the limit of my testing ability.)

*Through thorough testing we have learned that the TeslaTap will work on Pacifica's and Honda's with the following exceptions:
If using a High Power Wall Connector it must not be set for over 80 AMPS or under 32 AMPS.
        Only compatible with some of the new Tesla Model 3 UMC's and you must use only the NEMA 14-50 or 5-15 connector.

** Jaguar I Pace will not work if the HPWC or Destination Charger is set for 48 or 80 AMP charging signals. Charging has been verified at 32, 40, 56, 64, and 72 AMP settings.  

This adapter is NOT COMPATIBLE and is not to be used with the Tesla Super Charger Network.

Write a review

Note: HTML is not translated!
    Bad           Good

TeslaTap 80 AMP - HIGH POWER

  • Product Code: TeslaTap 80 AMP - HIGH POWER
  • Availability: In Stock
  • $239.95

Related Products

Mini Padlock

Mini Padlock

New larger Mini padlock with two keys. Fits the standard J1772 plug latch to prevent disconnects or theft...


TeslaTap Case

TeslaTap Case

MTM Snap Latch Case for TeslaTap.Outside Dimensions: 15.5" x 12.2" x 3.6"; Inside Dimensions: 14" x 10" x 3.1"  Rug..


Chemplex 862 Silicone Compound

Chemplex 862 Silicone Compound

CHEMPLEX¬© 862 Silicone Lubricant (Dielectric). Used to lubricate and insulate electrical connectors This is the bes..


Tesla Charging Station Voltmeter (VTHF1-T)

Tesla Charging Station Voltmeter (VTHF1-T)

Tesla charger Voltage Tester.Tester is enclosed in a IP-67 Weatherproof Hard Case.This tester is designed to test the ou..